Process tab
In this dialog a set-up for casting current segment is shown.
You can see schematic drawing of fixed bulkhead (it is at the bottom of the window), wet-cast segment and either match-cast segment or floating bulkhead depending whether your wet-cast segment is typical or starting. Depending on the types of rivets, the important values (offset, elevation or length) are shown in white box, remaining ones in gray box (or are not seen at all when Simplified frame is switched on).
Tool button will open a dialog where you can set whether you want full correction or parallel to casting curve. You can also set maximal correction angle there.
| Setting | Description |
|---|---|
| Include elevation | Add height of casting device to the elevation values |
| Hide disabled | Don't show values for rivets where all values wouldn't be displayed |
| Simplified frame | Either only values which are necessary for preparation of segment are shown or all the values are displayed. |
You can use arrows to change between seeing values for preparation of match-cast (floating bulkhead) and wet-cast. After everything is set up on site, it is possible to get to the next phase where the values will be surveyed.
